Piston ring set for Volvo B18, 0.040"

Piston ring set B18 0,040" – complete set for 1 engine

Complete piston ring set in +0,040" oversize for the Volvo B18 engine. The set contains piston rings for all four pistons and fits the Volvo PV, Duett, Amazon, P1800 and 140 with the B18 engine.

Fits the following models

• Volvo PV with B18
• Volvo Duett with B18
• Volvo Amazon with B18
• Volvo P1800 with B18
• Volvo 140 with B18

Specification

• Part number: 275285
• Engine: B18
• Version: Oversize +0,040"
• Bore diameter: approx. 85,16 mm
• Intended for B18 blocks that have been bored and honed to +0,040" oversize
• Quantity: Complete set for 4 pistons / 1 engine
• Volvo OE number: 275285

Reference numbers / OEM:
P1174.040, 50471040, 50471-040, 1174-040

Important fitting information

This piston ring set is +0,040" oversize and must only be used in B18 engines that have been bored and honed to this size. Always check the bore diameter before ordering.

When replacing piston rings, the cylinders should be honed so that the new rings have the correct surface to work against and can bed in properly. If the cylinders are not honed, there is a risk of poorer sealing and compression.

After fitting, the engine should be run in carefully. Avoid high revs and heavy loads immediately after the ring replacement. A good start is to let the engine run at a raised idle, approximately 1 500 rpm for 30–60 minutes, and then run the engine in gently.