Cylinder head set for Volvo B20E, B20F 1974-

Head Gasket Set for Volvo 140 – B20E, B20F from 1974

Head gasket set for Volvo 140 with B20E and B20F engines from model year 1974. The set is intended for cylinder head work and contains the gaskets required when removing and installing the cylinder head.

The gaskets are of high quality and sourced from well-known manufacturers, including Dana and Victor Reinz. The sets are picked and assembled at CVR’s own premises.

Fits the following models

• Volvo 140 from 1974

• Engine B20E

• Engine B20F

Specification

• Article number: 275560

• Alternative article number: HS560

• Type: Cylinder head gasket set

• Engine: B20E, B20F

• The set is picked and assembled by CVR

Good to know about the head gasket

For the B20 engine, head gaskets are available in three different thicknesses: 0.8 mm, 1.2 mm and 2.0 mm. The thickness selected affects the engine’s compression ratio.

0.8 and 1.2 mm are normally used for engines with twin carburettors or fuel injection, while 1.2 and 2.0 mm may be suitable for engines with a single carburettor.

A thinner head gasket gives a higher compression ratio, which can normally provide higher performance. A thicker gasket gives a lower compression ratio and can provide smoother engine operation, provided the engine is otherwise in good mechanical condition.

Important information

When using a thicker head gasket, it is especially important to follow the correct cylinder head bolt tightening sequence and torque specifications, as well as any retightening procedure specified in the workshop manual.