Syncrometer carburettor 40-55 mm universal, type SK
$ 146.34
- Engine:
- B4B, B14A, B16, B18
Tooling Carburettor Volvo PV/Duett
Uneven idle, pulling to one side under throttle or a car that never quite runs clean on twin SU carburettors are classic signs that the carburettors are out of sync. The right tools are then essential to balance the flows again.
- Syncrometer carburettor 40-55 mm universal, type SK
- SU carburettor tool kit
- Press tool for Volvo B20A, B20B, B30A (nozzle from below)
- Jet adjuster tool, Stromberg, for Volvo B20A, B20B, B30A
- Press tool for Volvo B20A, B20B, B30A (nozzle from above)
- Press tool for Volvo B20A, B20B, B30A
All products in category: Tooling Carburettor Volvo PV/Duett
SU carburettor tool kit
$ 78.54/set
- Engine:
- B4B, B14A, B16, B18, B20
Press tool for Volvo B20A, B20B, B30A (nozzle from below)
Amazon, 164, 140, 240
$ 48.03/set
- Model year:
- 1968–1970
- Engine:
- B20A, B20B, B30A
- System:
- Stromberg 175CD-2SE
- Info:
- Stromberg 175 CD-2SE
Jet adjuster tool, Stromberg, for Volvo B20A, B20B, B30A
Amazon, 164, 140, 240
$ 40.12
- Model year:
- 1968–1970
- Engine:
- B20A, B20B, B30A
- System:
- Stromberg 175 CD-2SE
Press tool for Volvo B20A, B20B, B30A (nozzle from above)
Amazon, 164, 140, 240
$ 39.78
- Model year:
- 1968–1970
- Engine:
- B20A, B20B, B30A
- System:
- Stromberg 175CD-2SE
- Info:
- Stromberg 175 CD-2SE
Press tool for Volvo B20A, B20B, B30A
Amazon, 164, 140, 240
$ 32.21
- Model year:
- 1968–1970
- Engine:
- B20A, B20B, B30A
- System:
- Stromberg 175CD-2SE
- Info:
- Stromberg 175 CD-2SE
Fast delivery
1 year warranty
On all parts for your Volvo
90-day returns
90-day right of return from delivery
Volvo expertise since 1999
We're here for you and your Volvo
This category gathers tools for the carburettors on the B-series 544 and 210/445, where twin SU or Zenith are often fitted. The group includes a syncrometer (flow meter) to measure airflow and sync the pair of carburettors, retainers for tappet, tool kits and other special tools for removal and adjustment.
A syncrometer is a common check point during a rebuild: after replacing needle valves or diaphragms, the flows need to be read off so that both carburettors draw the same amount of air. Always check that the tool fits the carburetor type before starting the job.