Welcome to an all-new Volvo experience and our new website.Read our guideGet a new passwordContact us if you have any problems

Skip to content

Front suspension Volvo 544/210 (1962-68)

Play in the steering wheel, clunks over speed bumps and uneven tire wear usually start with worn control arm bushings and dry grease nipples. On the 544 and 210 with strut-free front suspension, coil springs and Delco telescopic dampers carry the full load, and when the rubber in the control arms has dried out the wheel angles wander.

All products in category: Front suspension Volvo 544/210 (1962-68)

Lock washer

Lock washer

PV 544, Duett

$ 0.34
Position:
Centre
Model year:
1960–1968
Info:
For one side
Quantity per car:
2

OE numbers

18872
Taggbricka IZ13,2 till Volvo PV444, PV544, Duett, Amazon, Amazon Kombi, 1800, Volvo OE 940143

Tag washer IZ13.2 for Volvo PV444, PV544, Duett, Amazon, 1800

PV 444, PV 544, Duett, Amazon, 1800, 164, 780, S90

$ 0.28
Model year:
1961–1974
Axle:
Front axle
Dimensions:
1/2" (12.7 mm (0.50 in))
Engine:
B18, B20
Show more

OE numbers

940143
Spring washer M10 10.2x17.2x2.2 mm for Volvo PV444, PV544, Duett, Amazon, Amazon Kombi, 1800, Volvo OE 955922

Spring washer M10 10.2x17.2x2.2 mm for Volvo PV444, PV544, Duett, Amazon, 1800

PV 444, PV 544, Duett, Amazon, 1800

$ 0.17
Model year:
1955–1974
Material:
Steel
Dimensions:
3/8" (9.5 mm (0.37 in))
Thread:
M10
Show more

OE numbers

955922

Fast delivery

1 year warranty

On all parts for your Volvo

90-day returns

90-day right of return from delivery

Volvo expertise since 1999

We're here for you and your Volvo

This group includes bushings and bushing kits, complete control arm kits, bearing bolts, washers, rubber buffers and repair kits, plus grease nipples to keep the joints alive. The washers and bearing bolts control preload and play in the control arm joint, while the rubber buffers catch the impact at the suspension's end stop.

When rebuilding the front suspension it's smart to replace the upper and lower bushings in pairs and check the wear surfaces of the bearing bolts at the same time – otherwise a new rubber will quickly wear itself out against a worn bolt. Grease the nipples after installation so the joints last longer.